The U.S. Court of Appeals for the Seventh Circuit rejected a challenge by the National Roofing Contractors Association to the Occupational Safety and Health Administration’s December 2010 directive on the use of fall protection in residential construction. The directive withdrew an earlier one that allowed certain residential construction employers to bypass some fall protection requirements.
Data from the department’s Bureau of Labor Statistics estimates that an average of 40 workers are killed each year as a result of falls from residential roofs. One-third of those deaths represent Latino workers, who often lack sufficient access to safety information and protections. Latino workers comprise more than one-third of all construction employees.
OSHA’s new directive, Standard 03-11-002, rescinded the Interim Fall Protection Compliance Guidelines for Residential Construction, Standard 03-00-001. Prior to the issuance of this new directive, Standard 03-00-001 allowed employers engaged in certain residential construction activities to use specified alternative methods of fall protection rather than the conventional fall protection required by the residential construction fall protection standard. With the issuance of the new directive, all residential construction employers must comply with 29 Code of Federal Regulations 1926.501(b)(13). Where residential builders can demonstrate that traditional fall protection is not feasible, 29 CFR 1926.501(b)(13) still allows for alternative means of providing protection.
Construction and roofing companies have until June 16, 2011 to comply with the new directive. OSHA has developed training and compliance assistance materials for small employers and will host a webinar for parties interested in learning more about complying with the standard.
Source: Occupational Safety and Health Administration
Was this article valuable?
Here are more articles you may enjoy.